… The quasi-optimal cutting parameters are obtained … The milling cutting force is represented
by a tangential force … for quasi-optimal cutting parameters is given by the stability borderline (…

… internal torque loop, a quasi-optimal outer speed loop is proposed. This outer loop is time-…
of the reference; hence, the technique is quasi-optimal. The performance of the technique is …

… workpieces usually occur due to cutting forces. They limit the machining … Methods for
automatically evaluating the stability of a … 5, a quasi-optimal configuration for the selected …

… in the stability lobe diagram [1]. Ganguli et al. [9] and Munoa et al. … the dynamic cutting force
fca and active control force fc. … , “Adaptive quasi-optimal higher order sliding mode control …

… Mathieu equation, the stability analysis and stability charts of which … The resultant cutting
force is the sum of the cutting force … 24 , a quasi optimal time-periodicity is achieved when the …

… II we introduce the generic mathematical form of the optimal control problems (OCPs)
considered, and we give the formal definition of the optimal control policy to be learned by the …

… KAPITEL 3 / CHAPTER 3 3 QUASI-OPTIMAL CONTROL OF THE CUTTING FORCE
STABILIZATION LOOP OF MACHINE TOOLS DOI: 10.30890/2709-2313.2022-10-02-019 …

… This group accepts the machine tool … the cutting force. Merritt [28] in 1965 represented the
regenerative chatter of Tobias and Tlusty as a closed-loop system and applied Nyquist stability …

… principles of machine motion control: velocity stabilisation and … machine as a problem of
optimal control Quasi-optimal … is controlled in direct proportion to the cutting force. Note that …

… The problem of optimal control of cutting power parameters stabilization loops on … quasi-optimal
control of electric drives of machine tools to ensure the cutting force stabilization ...............…